Assemble the Metal Bars: Use the provided connector pieces to screw together two long metal bars.

NOTE FOR SIZE MINI:
Please skip this step if you purchased the size Mini.
Size Mini does not contain the A2 screw, since no bars need to be connected.

Attach Metal Bars to Tray: Insert one metal bar into the loops on the backside of the CableCare Tray. Then, insert the second metal bar into both loops of the CableCare Tray and the tray handles in between. Make sure the Ascrono logo on the fabric side is facing outward.

Secure End Caps: Screw on the end caps to prevent the metal bars from sliding off.

Mounting Bracket Installation: You have two options:

A. CLAMP INSTALLATION:
4A.1 Slide the clamp support bracket into the gap at the top of the mounting bracket, ensuring the prongs are oriented correctly with two outside prongs pointing downward, middle prong pointing upward.
4A.2 Insert the mounting screw from below the mounting bracket and rotate clockwise until the screw tip is visible.
4A.3 Attach the clip-on mounts to the screw tip.
4A.4 Slide the clamp angle brackets onto the mounting bracket through the prongs of the clamp support. If installed correctly, the middle prong should be the only prong visible while the outside prongs are supporting the clamp angle brackets.
4A.5 Secure the mounting bracket to the side of your desk and adjust for a snug fit.
4A.6 Repeat for the second mounting bracket.

B. SCREW INSTALLATION:
4B.1 Position the mounting bracket and secure it with table screws at each corner.
4B.2 Repeat for the second mounting bracket.

NOTE FOR BOTH INSTALLATIONS:
Notice the two hooks at the bottom of the mounting bracket with one wider and one narrow hook: place the narrow hook in the direction you will access the CableCare Tray.

When positioning the mounting brackets on your desk, refer to the measurements on the size dimensions below or on the sticker attached at the back of the product packaging. This measurement will vary per the size of the CableCare Tray.

Hang Metal Bars on Brackets: Hook the metal bars into the mounting brackets, ensuring the rear bar without tray handles is attached to the wider hook.

Secure Cables: Use the velcro attachments on the tray to secure power extensions, cables, and devices.

Final Attachment: Lift the front metal bar using the tray handles and attach it to the narrow hook of the mounting brackets.

Enjoy your Tidy Workspace: Revel in your newly organized desk setup! Take pleasure in the absence of messy cables cluttering the sides of your desk.